Do all of these come with the plug to plug in a remote? I bought a 2005 Lund that has 2 of these on it but i don't see the plug for the remote on them.
Minn Kota deckhand 25 and 40
I put a Deckhand 40 on the bow of my Navigator 165CS last year. I had to move my trolling motor to the very front of the bow to make room for the Deckhand. The Deckhand is mounted to a quick release plate so I can slide it back for trailering. Otherwise it would have stuck out pretty far when trailering. I still ended up having my cover modified because it would not fit over the trolling motor in it's new location. I also added the remote switch right behind my throttle controls so I can operate it from the console.
I have a Lund Rebel with a Minnkota deckhand on the front of the boat. I would also like to put one on the back. The issue is the back of the boat isn't flat like the front. Does anyone know where you can get a mounting bracket for the back of the boat or any suggestions on mounting a deckhand on the back of a boat?
I have 16 ft Sylvan with both in front. Trolling motor on left side. Deckhand 40 on right. I have MinnKota plate to slide Deckhand on and off when I’m done fishing.
Anybody have both a Deckhand 25 and a trolling motor on the front of a Alumacraft Class 1650?
I’m pretty sure it’s number 43 on schematic drawling. It’s been about 10 years since I replaced one. It’s very simple to do and you will know when you broke it and where it’s at. Because anchor will not come up and shaft is not spinning.
Click on link below for schematic drawing
Where are these shear pins everyone keeps mentioning ?
I don't see them on the drawings of manuals !!
I have the 40. Bought it about 10 yrs ago. Mine has the plug hanging off back of unit. It’s the black cord plug with 3 straight prongs in it. Remote comes with a lot of cord to reach unit. Make sure you have extra shear pins. Mine snapped couple times. Very easy to replace. Even on water. Just have screwdrivers and hammer and small punch to knockout piece if lodged in hole.