HOME
LAKES
REPORTS
FORUMS
TRAVEL
DEALS
SEARCH
MORE
Boats & Motors

12v to 24v Trolling Motor Upgrade

2/22/24 @ 3:47 PM
INITIAL POST
BugleTrout
BugleTrout
User since 9/27/01

I currently have a 12v Minn Kota Power Drive on my boat. It pairs well with my kicker to provide a decent auto-pilot for trolling but the Spot Lock feature is terrible. I’d like to upgrade to a 24v Terrova. My boat has room for a second Group 27 battery but I’m wondering how I would tell if the current gauge of the wiring is compatible/sufficient for a 24v system.

Any advice from others who’ve upgraded from 12v to 24v is appreciated. I’m mildly handy so I’m wondering if this is something I can do myself or if I should take it to a professional.

Displaying 1 to 9 of 9 posts
4/7/24 @ 2:30 PM
BugleTrout
BugleTrout
User since 9/27/01
Update: 

Got the boat out of the shed last weekend and started digging around the front of the boat to see what I all need to do to upgrade to 24v. Was expecting to have to pull and replace the wiring but after seeing "12-24V" on the quick disconnect plug, I was happy to find 6 gauge wire already in place. Sylvan wired it for either so that's gonna save me some time/money. The 60 amp marine circuit breaker arrived today and I will be ordering the motor and onboard charger this week. 

Thanks to you all for the advice/tips. Hoping to perform sea trials in the next couple of weeks to work out the kinks before the Opener! 
3/13/24 @ 10:01 PM
eyesman
eyesman
User since 1/7/02
Bugle, in your case with such limited use on your existing single battery you could break the rules and use it for one of the pair to get 24 volts. A matching battery would be best. 
3/13/24 @ 3:33 PM
BugleTrout
BugleTrout
User since 9/27/01
Related battery question:

I have read in multiple forums to get a matched set of deep cycle batteries for a 24 volt system. It's even mentioned below. If that's the best route to take, that's what I'll do. However, I replaced my group 27 deep cycle last spring with a Interstate. I hardly got to use my boat last season and never used the trolling motor. So the battery has never been drawn down or recharged. It's been kept on trickle charge most of the time. Should I still replace it when I pick up my second battery?
3/5/24 @ 10:59 AM
Jabberwalker
Jabberwalker
User since 4/21/04
A 12V 50/55 lb Thrust trolling motor draws the same amps as a 24V 80 lb Thrust trolling motor and both require a 60A Breaker per Minn Kota's guidelines. Wire size is determined by amps not volts. There is an inverse relationship between volts and amps, longer runs require larger wire due to the voltage drop. If you are not moving the battery placement it should be a simple swap. Just remember to hook the batteries in series and not in parallel.


12v to 24v Trolling Motor Upgrade photo by Jabberwalker
2/23/24 @ 6:29 PM
Bodhi77
Bodhi77
User since 1/9/21
Super easy to do yourself.If the wire isn't 6 ga I would pull it and rewire it with 6ga and put it in a 50amp breaker at the same time. Then pretty much all you have left to do it is hook it to the trolling motor and batteries, though you'll need a jumper wire to go between the batteries for a 24v. Then hook up your charger to 2 new batteries and you should be good to go. As far as ​mounting a new trolling motor also very simple though having an extra set of hands is very helpful. 
2/23/24 @ 2:31 PM
Guidedfishing
User since 8/2/01
Bugle Trout, 

This is an easy conversion,  Especially since you have room for two 12volt batteries.  You should be able to look at your current wires that go to the front.  Chances are you may need to upgrade although you could probably get away with 10 gauge, I would just pull it and replace with 6 gauge.  Use the same gauge wire to hook your new batteries that should be identical in make model and age in series.  Make sure you have a minimum of a 40amp fuse in line and you will be golden.   The other consideration is if you have an onboard charger you will need to run a 12 volt run to each individual battery to charge which is perfectly fine.
2/22/24 @ 6:38 PM
eyesman
eyesman
User since 1/7/02
If you are adding a second battery to make 24 volts strongly consider getting two new matching batteries. If your existing battery has much more than 6 months of age it will or soon will be the weak link of the 24 volt system and not preform as you want. Don’t get caught in the cycle of replacing one then the other over and over. 
2/22/24 @ 4:13 PM
Displaying 1 to 9 of 9 posts

HUMMINBIRD - APEX Series Sonar
APEX Series Sonar
Welcome to the top. The APEX™ Series provides the clearest sonar imaging on the sharpest display the water has ever seen on any GPS chartplotter. PRODUCT SPOTLIGHT: HUMMINBIRD - APEX Series Sonar Advertisement

MINN KOTA - Quest Series Trolling Motors
Quest Series Trolling Motors
Meet the all-new motors made with grit and guts – not glitz and glamour. The QUEST™ Series takes the best trolling motors ever made to the next level with a rugged build for rough waters. PRODUCT SPOTLIGHT: MINN KOTA - Quest Series Trolling Motors Advertisement

Copyright © 2001-2024 Lake-Link Inc. All rights reserved.
No portion of this website can be used or distributed without prior written consent of Lake-Link, Inc.
This website may contain affiliate links, meaning when you click the links and make a purchase, we may receive a small commission.
Lake-Link Home
fishing geared up by
MENU
MORE TO EXPLORE